hh505
05-08-2005, 01:32 PM
Well, after sacrificing a little hard earned cash, added hours for tool acquisition, not too exact instructions, and a little blood loss from a razor sharp sc to ic gasket, The KB now rests comfortably in it's designated position on top of a thoroughly cleaned intercooler assembly. (that was nasty inside). The bulk of the dirty work is done, and I still have to wire up and install electric fans and maf extender. No rush at this point since I will need to exchange one pulley to stay at a reasonable boost level. So for now I will be rechecking my work, aligning and tightening up the CAI stuff, getting fans in place, wiping off handprints,...
Looks cool with KB, polished C&L intake parts, pair of billet pulleys, and 9" crank pulley so far. Have pics, but not sure how to resize for posting. Putting them on a disc with my other club stuff for now.
Also, due to some misinformation, I will not be able to install my new billet idler assembly with the KB. So I will need to sell it. Brand new, nice quality part. Fits w/Eatons so anyone can use it. I put it on here first in case one of you want it. They sell for about $180-$190ish.
Can pm me, calling is easier for me 651-210-6673. Thanks, Howie
Looks cool with KB, polished C&L intake parts, pair of billet pulleys, and 9" crank pulley so far. Have pics, but not sure how to resize for posting. Putting them on a disc with my other club stuff for now.
Also, due to some misinformation, I will not be able to install my new billet idler assembly with the KB. So I will need to sell it. Brand new, nice quality part. Fits w/Eatons so anyone can use it. I put it on here first in case one of you want it. They sell for about $180-$190ish.
Can pm me, calling is easier for me 651-210-6673. Thanks, Howie